gokul
Guest
G
I have an extensive system with PLC 5/40 residing on a 12 slot chassis connected to other 8 slot chassis all connected over remote I/O. The system is working fine and was originally commissioned with ICOM software. I uploaded through RS Logix 5 software, but the I/O configurations are not matching with the physical I/O's. Instead of 16 slot local I/O chassis it reads as 4 slot chassis and so on. But the logic is viewd on line and change of states can be monitored. Whats the cause for above mismatch? Early reply highly appreciated
Thank you
Thank you