Hi All,
This is my first time using CCW with a Micro850 and a PanelView800.
The project I am working on will have the PanelView connected to multiple controllers via modbus (all of which will be offline at different times occasionally).
Because these controllers are running similar machines there is a need to enter the same settings (for timers etc, based on feed material properties and final product requirements) across each machine, does anyone know of a way that I can write the same data value to multiple tags?
Normally I would just use scripting to get the job done but this platform doesn't appear to support it (because it is a budget product I am assuming), are there any CCW wizards out there that know of a workaround?
Much Appreciated.
This is my first time using CCW with a Micro850 and a PanelView800.
The project I am working on will have the PanelView connected to multiple controllers via modbus (all of which will be offline at different times occasionally).
Because these controllers are running similar machines there is a need to enter the same settings (for timers etc, based on feed material properties and final product requirements) across each machine, does anyone know of a way that I can write the same data value to multiple tags?
Normally I would just use scripting to get the job done but this platform doesn't appear to support it (because it is a budget product I am assuming), are there any CCW wizards out there that know of a workaround?
Much Appreciated.