ryandodds7
Member
Hi,
I am currently trying to test some IO on a ET200S module, I have a constant 24V on all of the Digital Input terminals connected to the module, so when I’m trying to test push buttons I have 24V on each side and the input is not switching. Has anybody else came across this problem?
Set up is as follows;
24 & 0V connected to (1L+ 1M) ET200S Module
24 & 0V (2L+ 2M) connected from ET200s to power module (6ES7 138-4CA01-0AA0)
Power module connected to DI > DI > DI > DO > DO > termination plate
Hope anyone can help
Cheers
I am currently trying to test some IO on a ET200S module, I have a constant 24V on all of the Digital Input terminals connected to the module, so when I’m trying to test push buttons I have 24V on each side and the input is not switching. Has anybody else came across this problem?
Set up is as follows;
24 & 0V connected to (1L+ 1M) ET200S Module
24 & 0V (2L+ 2M) connected from ET200s to power module (6ES7 138-4CA01-0AA0)
Power module connected to DI > DI > DI > DO > DO > termination plate
Hope anyone can help
Cheers