OMRON NC113 Module to HIWIN Servo Driver

romerqazwsx

Member
R
Join Date
Sep 2018
Location
Laguna
Posts
5
Good day,


I am having a problem with outputting pulse to the HIWIN servo driver using the OMRON NC113 module.

The NC113 module is already outputting a pulse but the HIWIN servo driver wont recognize it. I am already sure about the settings on both the NC113 and HIWIN servo driver.

Here is my wiring.


NC113 Wiring (open pulse collector):
image.png


Here is the wiring on my HIWIN servo driver:
image.png



I9 and I10 ports are described on the manual as:


image.png



and the manual gave this wiring when using pulse command through host controller (single end) which is A6 and A8 on NC113:



image.png




This is the parameter setting on the HIWIN servo driver:


image.png





Thank you very much in advance!!!
 

Similar Topics

T
omron nc113 program
need some examples to program nc113.
Replies
10
Views
3,446
tlee1234
T
M
Struggling to get good connectivity with Omron PLC (CS) and KeserverEx
Hi There, I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...
Replies
4
Views
87
Mihir_007
M
A
Omron cj1m ETN cpu11 connection with NT631C
Hi dear . I have a system with cj1m cpu11 etn. previously NT 5z HMI was connected with plc. recently my old HMI got damaged. I want to replace it...
Replies
5
Views
89
IO_Rack
IO_Rack
K
Omron AD081-V1 Analog Input Card Calibration (Offset & Gain Adjustment)
Omron AD081-V1 Analog Input Card Offset & Gain Adjustment Entering Adjustment Mode 1. Set the input card in adjustment mode (Turn ON Dip SW No-1)...
Replies
0
Views
54
Ko Lin
K
S
Omron NB Screen & NX1P2 PLC Real Number issue
I am working on a project using a NB screen and NX1P2 PLC. I am having a really hard time getting a real number to properly translate through to...
Replies
3
Views
116
drbitboy
drbitboy
Back
Top Bottom