[Registration] read panelview plus 600

CHOIDRY

Member
Join Date
Jul 2018
Location
seoul
Posts
4
Hello
One thing I want to ask is.
I have been using the panelview plus 600, but I have seen that it is possible to read it in version 7 or later even if it is revised to 6.1.
So we upgraded 7 and 8 during firmware upgrade.
I have a fault in the panelview while I was uploading to 8.1 because the error window continued to appear. What if ...
 

Similar Topics

Hello all, I am trying to register a directory full of EDS files using the EDS Hardware Installation tool. But at 7% I am getting a weird...
Replies
4
Views
1,972
Good afternoon! Such a problem: There is a project, authorization works through the Archestra IDE. Platform 2012. It is necessary that when the...
Replies
1
Views
1,254
Attached is a sketch of our latest project, it's a retro fit of a Hudson Sharp bag machine. It's basically a rotary knife (perforator) in this...
Replies
25
Views
8,329
I just upgraded to V32 in order to take advantage of the new safety CPUs of the 5069 series IO. Unfortunately, none of the basic safety IO...
Replies
8
Views
2,819
Hello all, About every 3 or 4 months a Kinetix 5500 drive stops recognizing the registration event signal on input 2, even though you can see the...
Replies
12
Views
3,461
Back
Top Bottom