DaytonPLC
Member
I'm trying to add a safety generic module for a robot CIP. Anyhow, everything is grayed out and not allowing me to add IP address or change anything. Everything involving safety side is grayed out. Even my safety lock/unlock button is grayed out.
Although under the properties of the controller it says "Safety Application Unlocked"
I've tried both online and off line. I've tried key sw in REM and in Program mode.
Everything I have read on AB site says I need to put in a password but again that is after you click the safety lock/unlock button that is grayed out???
What am I missing???
Although under the properties of the controller it says "Safety Application Unlocked"
I've tried both online and off line. I've tried key sw in REM and in Program mode.
Everything I have read on AB site says I need to put in a password but again that is after you click the safety lock/unlock button that is grayed out???
What am I missing???