Hi guys
I was wondering if it is possible to split a pt100 probe signal , I have a pt100 going to a controller but I would like to piggy back off the probe and put into a plc , is this posible thanks
See if the controller has retransmit or use signal conditioner to send to the two devices. You can potentially run 4-20ma loop through both plc and controller.
oh
hello
Advice : you should use crush
and requests fabricate You should ask yourself
I want to you should use
crush
and requests
fabricate
You should ask yourself
I want to signal out 4-20ma or 0-10v
oh
hello
Advice : you should use crush
and requests fabricate You should ask yourself
I want to you should use
crush
and requests
fabricate
You should ask yourself
I want to signal out 4-20ma or 0-10v
Oh no
I mean the user must determine the output signal is 4-20ma or 0-10v. The purpose is to use a splitter to isolate two signals transmitted to two sets of control centers
I know a site specializing in this field
signal conversion 4-20ma to 0-5v
signal conversion 0-10v to 4-20ma
signal conversion rtd
signal conversion pt100
signal conversion TC
You can see more https://donghocambien.com
I hope this page will help you
good luck !