Slurryman
Member
I turn to the PLC gurus. We are running grout plants using the Melsec A series PLC's. The A2Ncpu is obsolete and no software. Is there a device to connect to extract data from a AD59/AD59MEM printer cable. I need so help...
AD59/AD59MEM Card
- Thread starter Slurryman
- Start date
http://www.plctalk.net/qanda/showthread.php?t=39286
This link may help you out in finding the cable and software.
Regards,
This link may help you out in finding the cable and software.
Regards,
Similar Topics
Omron AD081-V1 Analog Input Card
Offset & Gain Adjustment
Entering Adjustment Mode
1. Set the input card in adjustment mode (Turn ON Dip SW No-1)...
Hi All,
Has any of you tried to change the IP Gateway of the PLC (of course, essentially of the ENBT card), while in a redundant configuration...
What happens if you power up a 1783-MS10T with a Compact Flash card from a 1783-MS06T? Does it work, but with the "extra" ports unconfigured? If...
Hi , Where i can find Mitsubishi PLC Card end of line & replacement model details. i am looking for Q02CPU replacement model. Please advice. thanks
Am asking if we can upgrade sd ram and cf card of panel view plus ab by a normal sd ram and cf card but Allen Bradley to save cost because in ab...