SMC Flex comm loss Error on Devicenet

kamalaitounejjar

Member
K
Join Date
Feb 2006
Location
casablanca
Posts
39
hi to All,

is there any way to activate 20-COMM-D comm Fault action as Stop(or Fault) ONLY in Auto Mode and inhibit this action (hold last/zero) in Manual Mode.
I guess it doesn't make sense to stop or fault the SMC in Manual Mode because of a Network loss;In addition ,Manual Mode is generally used when we have a comm problem (PLC Idle/network..), so there's no need to have Starter stopped .

thanks in advance
 

Similar Topics

OkiePC
Controllogix to SMC Flex via 20-COMM-R
Customer installed two SMC Flex soft starters to replace Dialog Plus units that died. They have everything set up correctly on one of them and...
2
Replies
16
Views
4,963
Saffa
S
W
150 SMC Flex Soft Starter
Hi, I want to start 150 SMC Flex from Studio 5000. I have the AOP and P SMC flex AOI imported in my program. I have also set the logic mask to...
Replies
0
Views
306
waqas
W
moistcat
SMC Flex-E Soft Stop
Hi there, very much new to AB Drives / Drives in general. Driving a pump with SMC Flex Drive Rating: Pump (5-135) Revision 6.008. Currently the...
Replies
6
Views
2,149
alan_505
A
J
SMC Flex won't stop before full speed? !
Dear experts, I have encountered an SMC Flex (361A,480V) wired for 3-wire where that if you press 'Start' Then immediatly press 'stop' it will...
Replies
7
Views
1,766
JackPW
J
G
Smc flex
Hey guys We have an smc flex that faulted. Fault 14. Went through the troubleshooting guide ended up swapping the connections on the back of the...
Replies
1
Views
1,656
greggerrior
G
Back
Top Bottom