Hey fellas -
Just wondering if any of you have any familiarity with the Siemens Midimaster line of drives. I have one that died, and to be brutally honest I've never used a Siemens drive before. My question is can the board that has the operator on it be powered up so I can get all the relevant running parameters out of there??
I tried to look up info on this board to get a pinout of the ribbon cable that connects to it (and I assume gives it its power) but all the info on this board is in Japanese. G85139-E1721-A88 in case you were wondering.
Thanks,
Jay
Just wondering if any of you have any familiarity with the Siemens Midimaster line of drives. I have one that died, and to be brutally honest I've never used a Siemens drive before. My question is can the board that has the operator on it be powered up so I can get all the relevant running parameters out of there??
I tried to look up info on this board to get a pinout of the ribbon cable that connects to it (and I assume gives it its power) but all the info on this board is in Japanese. G85139-E1721-A88 in case you were wondering.
Thanks,
Jay
