HMI as Profibus Master?

ndzied1

Lifetime Supporting Member
Join Date
Aug 2002
Location
Chicago, Illinois
Posts
2,852
Hello all,

Is there an Operator Interface available that can perform as a profibus master? Most all seem to be slave only, which is probably where most of the market is anyway but I was just wondering.

Thanks
 

Similar Topics

Hi, I have a doubt about the system architecture shows below: could two master devices install in same profibus network?
Replies
4
Views
2,631
Apologises if this has been answered before but i can't find it if it has. I am a very new beginner to PLC's but have been tasked with a project...
Replies
0
Views
1,295
hello. we have a machine with sinumerik 840d(pcu50.3) and op77b. the op has been connected to profibus network with address number 8 but it isn't...
Replies
10
Views
2,853
Hi, I want to connect my HMI(tp177) by PROFIBUS DP. Do i have to set up any configuration? Because now it doesn't work. I put a profibus dp...
Replies
8
Views
2,022
I am new to the whole siemens programming. I have a s7-300 series PLC. ET-200S. I am typically installing GE PLC's. I finally figured out HW...
Replies
0
Views
1,987
Back
Top Bottom