Unity Pro with Momentum IO Problem

Hello,


I have a Schneider Electric Momentum 170 ADM 35010 base with a 170ENT11002 Communication Adapter and am trying to connect to it with Unity Pro but I cannot figure out how to get any kind of IP address from it.

I have the user guide and was able to calculate the default IP address from the Mac Address I think. I went from 00:00:54:25: D1:81 to 84.37.209.129. Correct me if I am wrong. But when i try to ping it or find it on a network scanner it isn't there.

Is there a way around this or is there any other way that I can configure this communication adapter?

Thanks.

You can automatically assign an IP using a DHCP server. If you're using an NOE or NOC card these have address servers. For the momentum adapter you use MAC address to assign an IP according to the manual. I haven't used these myself except on MB+ but I think they work similar to STB I/O

Alternatively you can set a fixed IP by accessing the http config page of the device using the default address you calculated. You will need to set your laptop to have an address on the same subnet, i.e. 84.37.209.50 or something like that.