Hello
Im using module 1794-IT8 to read values from termocouple type K. I configured the module to read this type of termocouple and i still get different temperatures than i should get, i get -5 for around 30 degrees.
Im not using cold junction and i would like to know, how can i compensate this with software? Is it even possible to compensate cold junction using software?
Regards
Im using module 1794-IT8 to read values from termocouple type K. I configured the module to read this type of termocouple and i still get different temperatures than i should get, i get -5 for around 30 degrees.
Im not using cold junction and i would like to know, how can i compensate this with software? Is it even possible to compensate cold junction using software?
Regards