AB VSD POWERFLEX 70, NO INTERNAL +10 v SUPPLY

Theboss

Member
Join Date
Jun 2010
Location
Durban
Posts
159
Good day,

I see on the wiring diagram that terminal 10 is + 10 v supply.
Not sure of its faulty or there is a parameter or jumper that enables it?

Need this +10 v to wire in a potentiometer for speed control.
 

Similar Topics

Hi, New to this so please bear with me. I have this controlling a Netzsch Progressive cavity pump at 30Hz and the pumps motor is rated at 21A...
Replies
6
Views
3,140
Hi, I have to add a powerflex 4m VSD onto a controlnet network, at the moment we have a powerflex 40 with an controlnet comm's card 22-comm-c...
Replies
3
Views
2,464
Hello Guys, Please I need assistance on how to configure Powerflex 755 VSD as MASTER & SLAVE setup in Rslogix 5000 using TCP/IP network. Please...
Replies
0
Views
2,597
In the manual it says that DI ENABLE parameter assigns an input to control the Enable drive function. Does this control start/stop? Or...
Replies
2
Views
1,440
Hi, I need some help on how to reset fault on the Powerflex 750 via ladder logic. I have looked through the parameter documentation and I...
Replies
5
Views
9,554
Back
Top Bottom