heavyadamek
Member
Hi.
I have a problem connecting my PLC (which is Hitachi ec2) with my personal computer. I'm not sure, but it can be caused because of broken switch. To be honest there is no switch on my board, that's why im connecting pins by wire.
Can somebody tell me how should i close these pins in each mode prg/com1/com2? Thanks in advance.!
I have a problem connecting my PLC (which is Hitachi ec2) with my personal computer. I'm not sure, but it can be caused because of broken switch. To be honest there is no switch on my board, that's why im connecting pins by wire.
Can somebody tell me how should i close these pins in each mode prg/com1/com2? Thanks in advance.!