Hello everyone,
I have been pulling my hair out on this one. I have been unsucessful in communicating Modbus TCP to a Eurotherm Data recorder using an Automation Direct D0-06 PLC. I have all but exhausted any tech support from either manufacture. The PLC is the master and the Eurotherm Data recorder would be the slave. I'm using the H0-Ecom100 ethernet card running through an ethernet cable to the Eurotherm. I have upgraded firmware in the processor to the latest automation direct has out. I have used the examples in the manual chapter 5 (in testing). I have converted the modbus address using Automation direct's conversion sheet (decimal to octal). Can anyone offer me any advice on this matter? Any helpful advice would be very appreciated.
I have been pulling my hair out on this one. I have been unsucessful in communicating Modbus TCP to a Eurotherm Data recorder using an Automation Direct D0-06 PLC. I have all but exhausted any tech support from either manufacture. The PLC is the master and the Eurotherm Data recorder would be the slave. I'm using the H0-Ecom100 ethernet card running through an ethernet cable to the Eurotherm. I have upgraded firmware in the processor to the latest automation direct has out. I have used the examples in the manual chapter 5 (in testing). I have converted the modbus address using Automation direct's conversion sheet (decimal to octal). Can anyone offer me any advice on this matter? Any helpful advice would be very appreciated.