data share betwwen two s7 plc... how to share and configure it..?
- Thread starter teh
- Start date
how to share the data from " data block " between 2 siemens s7 plc?PLucas
Member
Teh
The simple way would be to have the two PLC's connected on MPI and use the SFC's X_GET and X_PUT (SFC 67 and 68)
If you give us a bit more info on your setup and how much data you want to 'share' then we could be more specific.
Paul
The simple way would be to have the two PLC's connected on MPI and use the SFC's X_GET and X_PUT (SFC 67 and 68)
If you give us a bit more info on your setup and how much data you want to 'share' then we could be more specific.
Paul
Similar Topics
Hi, I have two systems each consisting of a Q03UDE connected to a Beijer E1070 all over Ethernet... I would like to share some REAL's over the...
How do you setup two processor (S7) to share the same Data Block?
Thanks
rmonroe
Hello
I have a s7-1200 and I would like to read the tags present in this controller with my controllogix controller. The two controllers don't use...
Hi folks,
I'm not as accustom with Siemens & WinCC, however I've been asked to increase the amount of data an existing application is logging...
Has anyone migrated Proficy Historian data to a new server? I followed the guide to move all the data over, but when I run the utility, it stops...