Hey All,
Sorry if this was answered in a previous post but I could not find it. I have a GE IC200UDR164 controller and I keep having an issue I have not come across before. When I download my program to the controller I get a system configuration fault. Normally when this happens it is because I forgot to put the correct controller in the configuration and it is a mismatch. I am using PME 9.0. In the bottom right corner of my screen I can see that it says Hardware Config Equal and Logic Equal. I can clear the stop/fault and run my program with no problems. If the PLC ever gets powered off then it goes into stop/fault mode upon boot up and I have togo in and clear the configuration fault. Please relieve me of this misery. Either the wall or my head is gonna bust.
Sorry if this was answered in a previous post but I could not find it. I have a GE IC200UDR164 controller and I keep having an issue I have not come across before. When I download my program to the controller I get a system configuration fault. Normally when this happens it is because I forgot to put the correct controller in the configuration and it is a mismatch. I am using PME 9.0. In the bottom right corner of my screen I can see that it says Hardware Config Equal and Logic Equal. I can clear the stop/fault and run my program with no problems. If the PLC ever gets powered off then it goes into stop/fault mode upon boot up and I have togo in and clear the configuration fault. Please relieve me of this misery. Either the wall or my head is gonna bust.