trespassingby
Member
Hello,
Trying to figure out if I can daisy chain powerflex 525's without using RS-485 cables and just using cat5 to the ethernet ports.
Each drive has its own IP address, furthermore all the drives are being recognized in RSlinx but aren't able to connect except for the main drive connected to the switch. The drives that are daisy chained after the main have an X through them.
After reading a lot of the threads my post probably sticks out like a sore thumb due to my inexperience -_-.
Any and all help is greatly appreciated, thanks.
Cheers
Trying to figure out if I can daisy chain powerflex 525's without using RS-485 cables and just using cat5 to the ethernet ports.
Each drive has its own IP address, furthermore all the drives are being recognized in RSlinx but aren't able to connect except for the main drive connected to the switch. The drives that are daisy chained after the main have an X through them.
After reading a lot of the threads my post probably sticks out like a sore thumb due to my inexperience -_-.
Any and all help is greatly appreciated, thanks.
Cheers
Last edited: