Good morning,
I would have a question to ask you.
I have a Micrologix 1100 to which I have to connect a PanelView C300 in ethernet. I have already created an application, through the browser of use in ".cha" to which, in the COMMUNICATION page I set my PLC with its address (192.168.1.1).
My question is:
1) do you need to give an IP address to the panelview via bootp / dhcp?
2) simply save the application on a pendrive usb and download it directly into the panel to allow communication with the plc?
The fundamental question is: how does the panel communicate with the plc?
Thanks so much.
I would have a question to ask you.
I have a Micrologix 1100 to which I have to connect a PanelView C300 in ethernet. I have already created an application, through the browser of use in ".cha" to which, in the COMMUNICATION page I set my PLC with its address (192.168.1.1).
My question is:
1) do you need to give an IP address to the panelview via bootp / dhcp?
2) simply save the application on a pendrive usb and download it directly into the panel to allow communication with the plc?
The fundamental question is: how does the panel communicate with the plc?
Thanks so much.