Does anyone know a load cells to PLC solution?
We are using “Survivor” and it malfunctions very often. I am thinking to propose a PLC instead of. I have learnt a little bit about Cells. It doesn’t look straightforward. It needs a signal conditioner and summing junction box in my case (we use 3 cells).
I’ve already found AEC blender solution with A-B M1500 controller, but it still is not simple. It uses digital input to count pulses I guess. I couldn’t upload that program.
So, does anyone have bad or good experience with design and using that? It would be too bad if I develop worse solution than it is.
Thank you.
We are using “Survivor” and it malfunctions very often. I am thinking to propose a PLC instead of. I have learnt a little bit about Cells. It doesn’t look straightforward. It needs a signal conditioner and summing junction box in my case (we use 3 cells).
I’ve already found AEC blender solution with A-B M1500 controller, but it still is not simple. It uses digital input to count pulses I guess. I couldn’t upload that program.
So, does anyone have bad or good experience with design and using that? It would be too bad if I develop worse solution than it is.
Thank you.