Delta HMI vs Micrologix 1400

Hello,
I want to connect a Delta DOP-107BV to a Micrologix 1400. Would a DOP-FX cable do the trick?? https://www.ebay.com/c/849453778 I dont think it's the same pinout for Allen-Bradley...
The cable I have right now is connected to a TouchWin HMI and a mitsubishi fx3ga-40mr. Maybe I can just modify the pinout on this one??
Thanks!

http://www.delta114.kr/board/filedown.php?ogfile=12385739100.pdf&filename=DOP-HMI_connection_en.pdf

The above link will take you to the connection manual.
Page 1-16 will show you the pinout.

You will probably have to make your own.
https://www.plccable.com/
These guys might have something on the shelf.

I hope this helps you out.
Regards,

gclshortt said:

http://www.delta114.kr/board/filedown.php?ogfile=12385739100.pdf&filename=DOP-HMI_connection_en.pdf

The above link will take you to the connection manual.
Page 1-16 will show you the pinout.

You will probably have to make your own.
https://www.plccable.com/
These guys might have something on the shelf.

I hope this helps you out.
Regards,

Click to expand...

Thanks Garry, I was reply to the thread when I saw your reply

I would contact Delta and see if they can provide the pinout of the HMI, you are correct when you say the China cable will not work... now that Garry replied, see the link for the pinout and if you can find a Mini DIN 8 you will need to connect to 2/3 and 5, 5 being your ground/comm and 2/3 being TX RX on the 1400

Best of luck
Mark (AKA GiT)

Thanks guys,
I bought this : https://www.ebay.ca/itm/DB9-Male-to...511676?hash=item5b5389017c:g:IaUAAOSwDyldb9vg
and will arrange the pinout to be as Delta proposes.

If you get something like these it will make easy and a cleaner install

https://www.winford.com/products/cat_brke.php

Just cut off the DB9 and find the pins/wires you need and wire it into the breakout

Hello, I'm trying to send recipe from my Delta HMI to Micrologix PLC. With Delta PLC, you would use ''D'' variablews to send Float, Srtring. Anybody knows how this would work for a Micrologix PLC??