20-COMM-E Firmware

waterbottle

Member
W
Join Date
Mar 2019
Location
Florida
Posts
42
Card was factory firmware 3 and i used control flash to upgrade to firmware 5.
Control flash said update was successful however when card boot MOD light flashes red. Manual says MOD blinking red means firmware not correct. However; on the him there are no faults.

Any ideas
 

Similar Topics

S
Micrologix 1100 Comm issue after firmware update?
Hello All, I was recently tasked with updating the firmware on all our Micrologix 1100s to v16. I took processors from the bench, flashed them...
Replies
4
Views
2,650
SpecialK87
S
dcooper33
PV+ 1000 Comm issues after Firmware Upgrade
Hi all, I was asked to change some stuff on the Runtime Security of a couple of PV+ 1000's that run on two different extruders, which function...
Replies
10
Views
6,414
dcooper33
dcooper33
R
Danfoss Aquadrive FC202 - Local command only if no comm
Hey guys. As the title suggests, I need to configure a Danfoss Aquadrive FC202 inverter, so that its logic inhibits the local command when the...
Replies
2
Views
45
Revnus
R
A
Ethernet comm problem with PLC when inverter enables.
Hi; In a cabinet of a machine, a Fatek PLC with an Ethernet communication card is working. In the same cabinet, there is a 1 kW inverter. When...
2
Replies
16
Views
499
Gleichner33
G
AutomationTechBrian
Modicon TSX Micro- Software, Comm Cable?
After updating a panel, I inherited another PLC for my "learning lab". It's a Modicon TSX Micro. I've not worked with a Modicon PLC yet, so I...
Replies
1
Views
134
tarik1978
T
Back
Top Bottom