Robb B
Lifetime Supporting Member
Happy Friday everyone!
I recently installed a new module, 1746 NIO4I, into the last slot on this chassis. Got the normal IO mismatch fault, added the module via "Read IO", saved the configuration, downloaded it to the processor, switched back to run mode, everything ran fine overnight. Today, I went to plug the terminal block into the card, and got faults. I've attached the two faults, and have since gotten them cleared by use of "Clear Faults" a few times. Just wondering if anyone else had issues like this? Possibly defective board? It was in a "Factory Sealed" box, looked to be authentic AB.
I recently installed a new module, 1746 NIO4I, into the last slot on this chassis. Got the normal IO mismatch fault, added the module via "Read IO", saved the configuration, downloaded it to the processor, switched back to run mode, everything ran fine overnight. Today, I went to plug the terminal block into the card, and got faults. I've attached the two faults, and have since gotten them cleared by use of "Clear Faults" a few times. Just wondering if anyone else had issues like this? Possibly defective board? It was in a "Factory Sealed" box, looked to be authentic AB.
Last edited: