20-COMM-E Firmware

waterbottle

Member
W
Join Date
Mar 2019
Location
Florida
Posts
42
Card was factory firmware 3 and i used control flash to upgrade to firmware 5.
Control flash said update was successful however when card boot MOD light flashes red. Manual says MOD blinking red means firmware not correct. However; on the him there are no faults.

Any ideas
 

Similar Topics

S
Micrologix 1100 Comm issue after firmware update?
Hello All, I was recently tasked with updating the firmware on all our Micrologix 1100s to v16. I took processors from the bench, flashed them...
Replies
4
Views
2,640
SpecialK87
S
dcooper33
PV+ 1000 Comm issues after Firmware Upgrade
Hi all, I was asked to change some stuff on the Runtime Security of a couple of PV+ 1000's that run on two different extruders, which function...
Replies
10
Views
6,406
dcooper33
dcooper33
A
Ethernet comm problem with PLC when inverter enables.
Hi; In a cabinet of a machine, a Fatek PLC with an Ethernet communication card is working. In the same cabinet, there is a 1 kW inverter. When...
2
Replies
16
Views
492
Gleichner33
G
AutomationTechBrian
Modicon TSX Micro- Software, Comm Cable?
After updating a panel, I inherited another PLC for my "learning lab". It's a Modicon TSX Micro. I've not worked with a Modicon PLC yet, so I...
Replies
1
Views
128
tarik1978
T
W
22-COMM-E EXPLICIT MSG
Guys need a bit of help getting the instance correct for a 22comme with a PF40P. Trying to get 2 things first is the drive current amp draw...
Replies
1
Views
86
Ken Roach
Ken Roach
Back
Top Bottom