Hello everyone. I have installed a remote Flex i/o enclosure with a AENTR ethernet adapter and an 1794-IR8 RTD card. I have landed 4 Rtd’s on this card. The RTD’s are 3 wire PT100’s with a Fahrenheit range of -58 – 572. I have tried using an AOI scale block and tried using some other scaling methods we have and nothing seems to work. I have tried reading the 1794-IR8 manual, but it’s not very helpful (To me anyways). Is there certain config bits on this card that need to be set? I have never used one of these cards before. Any thoughts or ideas? Anything would be appreciated.