coibarra
Member
Hello All!
I'm using an Allan-Bradley PLC (ControlLogix L61) and would like to know if its possible to make a 3 dimensional matrix. I want to populate each cell (i.e. 10x10x10 would have 100 cells with predefined values) and I would like the program to be able to pull the value from the cell depending on what the user input is.
Example: a 10x10x10 matrix is populated by me with 100 random values. I would like to pull the value from the [5,4,3] spot at my command.
This will get me basic functionality of my end goal but I might be able to finish it up if I know where to start.
Any ideas?
I'm using an Allan-Bradley PLC (ControlLogix L61) and would like to know if its possible to make a 3 dimensional matrix. I want to populate each cell (i.e. 10x10x10 would have 100 cells with predefined values) and I would like the program to be able to pull the value from the cell depending on what the user input is.
Example: a 10x10x10 matrix is populated by me with 100 random values. I would like to pull the value from the [5,4,3] spot at my command.
This will get me basic functionality of my end goal but I might be able to finish it up if I know where to start.
Any ideas?