POWER_PACKED
Member
- Join Date
- Apr 2004
- Posts
- 48
Hi everyone - I know this is not a PLC related question, but couldn't find a better suitable place to ask this question. I have a DVT Legend 500 Series Camera that I got set up, I am trying to check if an operator installed the correct type of bolts before the product gets fed to an auto torque station. I have got the soft sensors set up, and they work fine, For these two bolts I had to create two different products to inspect in the DVT, product 1 to check bolt1 and product 2 to check bolt2 I know its possible to switch between products "also called inspecting programs" using a 24V signal 0 for product 1 and 24VDC=1 for product 2. I have set up pin1 as my trigger pin2 as Pass pin3 as fail pin4 as Product ID bit 0. I don't seem to be able to switch between products while the camera is running! I don't know what I am missing, I read the FrameWork 2.7.3 software manual and I did exactly what was instructed. I am 100% the 24VDC I am sending is getting to the I/O board.
Anyone worked with DVT should know what I am talking about and should be able to help me "I hope"
Thank you,
Anyone worked with DVT should know what I am talking about and should be able to help me "I hope"
Thank you,