protec
Member
Hello Gurus,
I have an analog, D.P. sensor; The reading bounces between .4 & .56 Inches of water coming into V3000 (0-4095).
I need to use this signal in a PID loop so an average of the input over a 10 second time would be better to keep the PID from modulating it’s output too much.
I’m not sure how to take several readings and then average them in my Automation Direct PL-450 PLC.
Any comments, help etc. would be welcomed and appreciated!
Thanks, Mark
[email protected]
I have an analog, D.P. sensor; The reading bounces between .4 & .56 Inches of water coming into V3000 (0-4095).
I need to use this signal in a PID loop so an average of the input over a 10 second time would be better to keep the PID from modulating it’s output too much.
I’m not sure how to take several readings and then average them in my Automation Direct PL-450 PLC.
Any comments, help etc. would be welcomed and appreciated!
Thanks, Mark
[email protected]