Hello everyone,
i want to connect these 3 devices:
1. Micrologix 1400
2. Mitsubishi Inverter D700-SC
3. Simple laptop or PC
So, my VFD only supports Modbus/RTU according to the manual (RS485).
I want to connect all 3 of them through ethernet network.
I also have a Digi One IAP HAZ for the Ethernet- Modbus/RTU conversion.
Something similar to this:
aaand it's not working. Do i need a second Digi or it should be working just like this?
Do you need to upload my channel configuration and my ladder code for the MSG?
My second plan if this doesn't work out is to connect
1. The RS485 of VFD to RS232 port of Micrologix through a RS232 to RS485 converter
2. Micrologix with an ethernet cable with my laptop.
And it's not working either. I am a student, so i don't know exactly which steps i should take to ckeck where the problem is.
Thank you and sorry for my bad english.
i want to connect these 3 devices:
1. Micrologix 1400
2. Mitsubishi Inverter D700-SC
3. Simple laptop or PC
So, my VFD only supports Modbus/RTU according to the manual (RS485).
I want to connect all 3 of them through ethernet network.
I also have a Digi One IAP HAZ for the Ethernet- Modbus/RTU conversion.
Something similar to this:
aaand it's not working. Do i need a second Digi or it should be working just like this?
Do you need to upload my channel configuration and my ladder code for the MSG?
My second plan if this doesn't work out is to connect
1. The RS485 of VFD to RS232 port of Micrologix through a RS232 to RS485 converter
2. Micrologix with an ethernet cable with my laptop.
And it's not working either. I am a student, so i don't know exactly which steps i should take to ckeck where the problem is.
Thank you and sorry for my bad english.