I am looking for some programming software for some old PLCs we have on site.
They are Cutler Hammer CH40 or NEC PL40M Mk2.
It is the same PLC, just looks like one was built under licence to the other.
The situation, we still have quite aa few on site, and it will be a few years before they can all be replaced. We are using hand held programmers, but would like a way to archive the programs on our server.
Does anyone know what software can be used to program these things and which company sells it?
Local support dried up years ago.
Thanks,
Doug
They are Cutler Hammer CH40 or NEC PL40M Mk2.
It is the same PLC, just looks like one was built under licence to the other.
The situation, we still have quite aa few on site, and it will be a few years before they can all be replaced. We are using hand held programmers, but would like a way to archive the programs on our server.
Does anyone know what software can be used to program these things and which company sells it?
Local support dried up years ago.
Thanks,
Doug