CapinWinky
Member
I need to send some explicit messaging from a PacDrive3 to an Eth/IP device and I can't seem to find any documentation about it. I'm using SoMachine Motion Logic Builder V4.1.
I can add the device to my Ethernet/IP scanner and I see that it has a User Parameters tab when I click on it for sending one time, hard coded values via explicit messaging at boot. The problem is, I need to read and write values and commands, so this hard coded writing isn't going to fly.
Looking at the Connections tab, it looks to be exclusively for implicit communication. Is there a function or something I'm supposed to use? Schneider's help files are atrocious, so I'm kind of in the dark on this.
I can add the device to my Ethernet/IP scanner and I see that it has a User Parameters tab when I click on it for sending one time, hard coded values via explicit messaging at boot. The problem is, I need to read and write values and commands, so this hard coded writing isn't going to fly.
Looking at the Connections tab, it looks to be exclusively for implicit communication. Is there a function or something I'm supposed to use? Schneider's help files are atrocious, so I'm kind of in the dark on this.
