Hello, I Have a GE Fanuc RX3i that I migrated that Has a IC695CHS012 for the Main Rack and 4 IC693CHS392 Expansion Less than 50Ft. I ran across where they had a IC693APU300 Rev H High Speed Counter Module in the 2nd Rack IC693CHS392 and I could not get this to work in the Expansion and Had to do some changes and Put it in the Main Rack and it worked as it should. In GFK-2714 It says the Module will work in the Universal CHS or the 693 Expansion. Anyone ran into this or know if I may of done something wrong.. I did notice the OK was lit but the CFG was not in the Expansion but in the main Rack Both were lit..
1.3.2 Series 90-30 (IC693) Modules for RX3i Systems
The following table lists the 90-30 modules that are compatible with the RX3i serial bus in Universal
Backplanes, RX3i Serial Expansion Backplanes and 90-30 Expansion Backplanes. Page 8-9
1.3.2 Series 90-30 (IC693) Modules for RX3i Systems
The following table lists the 90-30 modules that are compatible with the RX3i serial bus in Universal
Backplanes, RX3i Serial Expansion Backplanes and 90-30 Expansion Backplanes. Page 8-9