Power up s:1/15

I think you hit the nail, I looked at HMI and had switch as (set on) Weintek
instead of momentary. I will upload tonight and watch online.
 
mylespetro said:
What I usually do is have the first pass bit enable a timer with a preset of 0.5 sec just in case it doesn't trigger, but that's usually in front of logic that's a little more involved. Just ensures that the following logic sees the first pass bit go true.
Click to expand...


Just want to clarify, the first pass enables a TOF timer, not a TON.
 

Similar Topics

J
iTools -- Eurotherm E-Power
First time I've used either the software or this unit. This is the setup I have right now. I have 20mA coming into AnalogIP1. Both the Main.PV...
Replies
0
Views
27
just_lionel
J
S
Plc power indicator on but run and error indicators off
Hello..I am new to Plc.I have Mitsubishi Melsec Fx3Ga-40MR PLC controlling a machine for packing powder.Currently the Plc has issue which power...
Replies
3
Views
110
parky
P
S
Modbus TCP connection between my plc and a power meter on TIA Portal
Hello gentlemen, Im working on a small project on TIA Portal, about establishing a Modbus TCP connection between my ET200SP plc and a socomec...
Replies
12
Views
288
joseph_e2
J
T
Power Supply Protection
I have the power supply in the link below. If we want a breaker to isolate and protect the input side how would I size that correctly being 120...
Replies
8
Views
200
JesperMP
JesperMP
S
Power Flex 527 , safety inhibitor fault
Power flex 527 Network based safety drive had faulty and alarm pop up SOS Code internal fault Unable to set or clear the fault manually or...
Replies
5
Views
115
arpus4KM
A
Back
Top Bottom