sparksy@gage
Member
We have acquired a secondhand panelview 1000 2711-T10C3 which we want to load a existing application from a smaller panelview onto.
Been trying to connect using RSLINX via Rs232 but with no luck. Have got into the configuration screens on the Panelview 1000 and it shows the RS232 port has been set for printer use. The PV1000 has a existing application on it.
Is there anyway I can reset the the panelview to factory defaults or remove the existing application so I can download via the serial port.
I can connect to the existing smaller panelview so I know the serial usb adaptor and serial cable is OK
Thanks
Wayne
Been trying to connect using RSLINX via Rs232 but with no luck. Have got into the configuration screens on the Panelview 1000 and it shows the RS232 port has been set for printer use. The PV1000 has a existing application on it.
Is there anyway I can reset the the panelview to factory defaults or remove the existing application so I can download via the serial port.
I can connect to the existing smaller panelview so I know the serial usb adaptor and serial cable is OK
Thanks
Wayne
Last edited: