Adam Bullen
Member
Does anyone know if you can get to the original code from a Moeller MC4 file?
I saw this thread http://www.plctalk.net/qanda/showthread.php?t=58059 and was able to get the Sucosoft S40 demo program and upload out of the PLC; however the only files available were xxxx.MC4; BOOT.lst and RSDAT.DAT. There was also a xxx.PCD file but I couldn't upload that one.
I am used to working with Rockwell PLC's so this is a first for me; this old PLC is going to be replaced by a remote rack to one of the main plant PLC's. It is going to be a re-write either way but having a copy of the old code would speed things up a bit.
I saw this thread http://www.plctalk.net/qanda/showthread.php?t=58059 and was able to get the Sucosoft S40 demo program and upload out of the PLC; however the only files available were xxxx.MC4; BOOT.lst and RSDAT.DAT. There was also a xxx.PCD file but I couldn't upload that one.
I am used to working with Rockwell PLC's so this is a first for me; this old PLC is going to be replaced by a remote rack to one of the main plant PLC's. It is going to be a re-write either way but having a copy of the old code would speed things up a bit.