benmccormick
Member
Hi guys!
I need help urgently!!!
We are about to have a week-long shutdown at our factory and I am afraid we will drop the program on 2x old Mitsubishi K0J1E-DT-AC220 PLCs.
I have been searching all over the place to try and run the programs!
It seems we have backups (although I would prefer to take current ones) but I cannot open them.
They are the following format:
.HDR
.NAM
.PRG
I have tried converting with GX but it does not seem to be supported.
I have downloaded MEDOC V1.64(?)
When I try to open the files, MEDOC tells me "This system is not available"
I run a W7 environment. I have tried running an XP system, and also booting straight to DOS in both. No luck.
I see when I installed MEDOC, I received some files *.typ EG. F2.typ, FX0.typ etc.
I am wondering if these relate to the PLC type?
The only .typ files that came with the program are F*.typ, and as my "PLC-types" are K0J, perhaps this is why?
However I have searched the net far & wide and cannot find any information.
Can anyone help me????
I need help urgently!!!
We are about to have a week-long shutdown at our factory and I am afraid we will drop the program on 2x old Mitsubishi K0J1E-DT-AC220 PLCs.
I have been searching all over the place to try and run the programs!
It seems we have backups (although I would prefer to take current ones) but I cannot open them.
They are the following format:
.HDR
.NAM
.PRG
I have tried converting with GX but it does not seem to be supported.
I have downloaded MEDOC V1.64(?)
When I try to open the files, MEDOC tells me "This system is not available"
I run a W7 environment. I have tried running an XP system, and also booting straight to DOS in both. No luck.
I see when I installed MEDOC, I received some files *.typ EG. F2.typ, FX0.typ etc.
I am wondering if these relate to the PLC type?
The only .typ files that came with the program are F*.typ, and as my "PLC-types" are K0J, perhaps this is why?
However I have searched the net far & wide and cannot find any information.
Can anyone help me????