Melsec motion control training

sawyer65

Member
S
Join Date
May 2016
Location
Auburn,AL
Posts
21
Could anyone recommend a video series or even hard copy of how to setup a q series motion controller.
I have a Q03UDCPU,Q173DCPU,MR-J3-100 and a HF-KP43 motor.
I have download several binders of Melsec manuals and I can't seem to get it configured properly.
I think I have all the software, GX-works 2 and 3 and Mt Developer2.
Ideally, I am looking for something that will take me right from scratch to being able to run a few basic move commands.
 

Similar Topics

A
Mirsubishi Melsec/Shihlin PLC Software
Hi everyone, I have a small project for an industrial site entry gate system. It's running on an old Melsec PLC, and I have a new Shihlin PLC...
Replies
1
Views
130
parky
P
C
Melsec Medoc - program print
Anyone have access to Melsec Medoc plus 2.31a that can either open a file (.pcd zipped in link below) and send a PDF/screenshot of the ladder, or...
Replies
10
Views
381
parky
P
T
Mitsubishi FX-48MR (Melsec Medoc)
Hello! First time poster and a big PLC newbie so I am looking for some backup here. I have an old Mitsubishi FX-48MR that lost its program...
2
Replies
15
Views
514
lfe
L
Y
How to copy program from an old Melsec FX1S-20MR to a new one?
Hi I have a Melsec FX1S-20MR, which has been programmed. I would like to copy the program to a new FX1S-20MR? What are the possible ways to do...
Replies
4
Views
619
JONES DCY
JONES DCY
A
Melsec CC-Link IE TSN master does not transfer process data to PLC
Hello parky, goghie, Brian and all of you who kindly come to help when I get stuck. I cannot look into the clock issue that parki has written for...
Replies
5
Views
856
AlfredoQuintero
A
Back
Top Bottom