Hello there.
I'm using PowerFlex 525, 0.5 HP, 230V, firmware 5.1 and RS Logix 5000 v.20 software.
Is there a way to set in Logix 5000 a parameter, that is displayed after Drive's boot? I need it to display frequency (b001 from basic display category) but it is set to display voltage (b004). I know it's easy to simply change it manually, but is it possible to change it without taking a drive out of the control cabinet, just by sending message (Set Single Parameter) from RSLogix software?
Thanks in advance :>
I'm using PowerFlex 525, 0.5 HP, 230V, firmware 5.1 and RS Logix 5000 v.20 software.
Is there a way to set in Logix 5000 a parameter, that is displayed after Drive's boot? I need it to display frequency (b001 from basic display category) but it is set to display voltage (b004). I know it's easy to simply change it manually, but is it possible to change it without taking a drive out of the control cabinet, just by sending message (Set Single Parameter) from RSLogix software?
Thanks in advance :>