Mitsubishi PLC comms

QMS_MAN

Member
Join Date
Jun 2015
Location
uk
Posts
9
Hi All,

I have two Mitsubishi Q series PLC's ( Q03UDECPU ).

Both are connected via a basic ethernet switch.

I need to read and write about 100 words of data between each PLC.

This is not a high speed application.

This is a new project using GX Works 2.

What is the best way to achieve this task.

Any help or examples appreciated.

Thanks in advance.
 
Hello,
You will need to go into the PLC parameters in GX Works 2, under the Ethernet port tab go to open settings. In there you can configure the communication between the two PLC's.

Hope this helps.

Dave
 

Similar Topics

I have Toyopuc PLC PC10G-CPU and some communication modules of it. With this modules I'm able to connect with Ethernet, Ethernet/IP, FLnet, FRMT...
Replies
0
Views
52
Hi all, anyone does have experience in Gx Works 2? Currently I having an issue which is when certain device added from MELSOFT Navigator and...
Replies
1
Views
92
Hi All, I am after some assistance setting up kepware to take tag data from an FX5U PLC, I have tried many many port numbers and still cant get a...
Replies
2
Views
118
Dear All, I have an Mitsubishi PLC (FX1N-40MR) and PLC backup was taken and i compiled the program and its showing 0 error. then I tried to...
Replies
8
Views
226
Currently,we are facing the communication go through with 422 tx+ and tx-. Mitsubishi fx5u series is used and using command rs2. But the package...
Replies
0
Views
91
Back
Top Bottom