puisan77
Member
Dear all,
Anyone please advise me on the Configuration of
EtherNet/IP to Modbus Mapping.
Attached Config.bin file which I have made, and
after uploading this file to the device
(GC-XPORT-EIP-MB) and rebooting, it doesn't reply
to PING, nor could the old configuration file
be uploaded to it. This is my first time doing
this kinda project and has little understanding
about MODBUS.
Please advise.
Attached manual from GridConnect and ConfigFiles.zip
Under ConfigFiles.zip, Config-xxx.bin is the file
that caused the device to stop responding after it
has been uploaded to the device, and
config.bin is the one, which works fine, till now (but
without any Modbus Mapping)
With Best Regards
Puisan
Anyone please advise me on the Configuration of
EtherNet/IP to Modbus Mapping.
Attached Config.bin file which I have made, and
after uploading this file to the device
(GC-XPORT-EIP-MB) and rebooting, it doesn't reply
to PING, nor could the old configuration file
be uploaded to it. This is my first time doing
this kinda project and has little understanding
about MODBUS.
Please advise.
Attached manual from GridConnect and ConfigFiles.zip
Under ConfigFiles.zip, Config-xxx.bin is the file
that caused the device to stop responding after it
has been uploaded to the device, and
config.bin is the one, which works fine, till now (but
without any Modbus Mapping)
With Best Regards
Puisan