Omron CJ1W-ETN21

kevinkevin

Member
K
Join Date
Sep 2016
Location
Kuala Lumpur
Posts
9
Hello all, has anyone configured before 2 CJ1W-ETN21 in a single rack?

I am trying to put 2 units of ETN21 couple with my CJ2M-CPU33 to act like a redundant Modbus Master polling station, as the other party is also a redundant. Is this configuration possible?
 
No - Modbus only has one master. I have managed to organise 2 Modbus masters in a Red Lion protocol translator though - not the same.
 

Similar Topics

J
Omron CJ2M PLC with CJ1W-ETN21 card
Hello everyone, I would like advice on the setup below: CJ2M PLC: 192.168.10.01 (Subnet: 255.255.255.0) ETN21 - 192.168.20.1 (Subnet...
Replies
6
Views
1,846
Jothiswarup
J
scrambled
Omron CJ1W-ETN21 connection to NS8 HMI
Hi all, I have a customer that has a series of around 15 Omron CJ1M PLC's, each connected to an Omron NS8 HMI via an ETN21 module. The PLC and...
Replies
0
Views
2,904
scrambled
scrambled
scrambled
Omron CJ1W-ETN21 Automatic Address Generation Error
I have an Omron CJ1M PLC that does Modbus TCP comms via an CJ1W-ETN21 Ethernet module. At the moment, I have set the ETN21 to automatically...
Replies
2
Views
4,037
scrambled
scrambled
J
omron cj1w-etn21 version change
Hi, I'm having difficulty configuring the ethernet card on on our Omron CJ2H-CPU66 rack. Using the PLC IO table to configure the ethernet card...
Replies
1
Views
3,651
BobB
BobB
R
Pulse Output PLC Omron CJ2M with CJ1W OD211
I have PLC Omron CJ2M with OD211 module. I want to use the pulse output and PWM output and this module. But i confuse how to activated this, i...
Replies
0
Views
89
rakhafrds30
R
Back
Top Bottom