I stole a 525 control module (Cat no. 25B) and put it on a drive from another VFD to get a process up and going.
The VFD the control module was on had a different HP rating so I have a mismatch. I've done this before via the USB port.. but for some reason I cannot get any of the 525s USB driver to work anymore...
Anyways, I'm trying to change the driver properties via Ethernet. I use the boot tool to change the IP and all that, I can communicate and change parameters but I cant change the HP ratings and other properties online. I go offline, change the properties to the new VFD hp and try to download.
It prompts a warning saying the properties are different than the control module and I click continue and nothing changes!
I tried it in the workbench program and studio.
Any ideas?
The VFD the control module was on had a different HP rating so I have a mismatch. I've done this before via the USB port.. but for some reason I cannot get any of the 525s USB driver to work anymore...
Anyways, I'm trying to change the driver properties via Ethernet. I use the boot tool to change the IP and all that, I can communicate and change parameters but I cant change the HP ratings and other properties online. I go offline, change the properties to the new VFD hp and try to download.
It prompts a warning saying the properties are different than the control module and I click continue and nothing changes!
I tried it in the workbench program and studio.
Any ideas?