catalin123
Member
Hello.
The command for force set is:
@ a b K S OP1 OP2 OP3 OP4 W1 W2 W3 W4 BIT1 BIT2 FCS1 FCS2 * [ent]
a,b = Unit No.
OPx = Area
Wx = Word address
BITx = the bit
[ent] = chr(13)
As i remember -from a long time ago- i was using something like:
"@01KSCIO 010001[FCS]*[ent]"
The problem is that now -ofcourse- this doesn't work any more, as i have another unit.
How would i set OPx, Wx and BITx if i need to force set input #1 on the base(the CPU)?
How do i know what unit number to use ?
(as i know, this is the same as for Omron CQM1)
Ty.
The command for force set is:
@ a b K S OP1 OP2 OP3 OP4 W1 W2 W3 W4 BIT1 BIT2 FCS1 FCS2 * [ent]
a,b = Unit No.
OPx = Area
Wx = Word address
BITx = the bit
[ent] = chr(13)
As i remember -from a long time ago- i was using something like:
"@01KSCIO 010001[FCS]*[ent]"
The problem is that now -ofcourse- this doesn't work any more, as i have another unit.
How would i set OPx, Wx and BITx if i need to force set input #1 on the base(the CPU)?
How do i know what unit number to use ?
(as i know, this is the same as for Omron CQM1)
Ty.
