Hello!
Our PLC stopped working.(Controller CPU hardware failure)
What can we do?
https://prnt.sc/txskqe
Our PLC stopped working.(Controller CPU hardware failure)
What can we do?
https://prnt.sc/txskqe
Last edited:
Versamax PLC IC200UDR005-CJ fault
- Thread starter buferk
- Start date
Steve Bailey
Lifetime Supporting Member + Moderator
Replace it.
You have a backup copy of the program and the software and cable necessary to send the backup copy to the replacement unit, don't you?
You have a backup copy of the program and the software and cable necessary to send the backup copy to the replacement unit, don't you?
Steve Bailey
Lifetime Supporting Member + Moderator
The cost of those units is so low that they aren't considered to be worth repairing. Power quality is one possibility.
Similar Topics
Hi,
The VersaMax PLC suddenly stop running (no LED on run function) so I'm trying to upload the program.
The HMI connected to it says "Host...
Hi,
I am trying to set the IP address on the IC200UEM001 Ethernet Option Module. I am following the procedure in the manual for setting a...
I'm trying to utilize a PLC that my employer already had on hand for a project. For the life of me, I can't figure out how to get my computer and...
Every time i turn off and turn on the PLC, PLC is not going to RUN mode
In the fault table it shows error " system Configuration mismatch"
And...
I have a versamax PLC and I am trying to write some ladder logic in Proficy Machine Edition that will turn an output 30 seconds ON then 30 seconds...