Status Byte for Fault Information -- Wago 750 -471

Sham

Member
S
Join Date
Sep 2019
Location
Australia
Posts
152
hi all,

can you guys pleas help in how to access the status byte for Wago 750-471 Analog input sensor? I am using E ****pit for the first time.

Documentation says CH1_S0 and I have no clue beyond this.

Thaks
 

Similar Topics

P
S7 PM-E Status byte
I am using a ET200s with some normal IO and some safe IO powered by several PM-E DC 24V (138-4CA01-0AA0). I was intending to enable the status...
Replies
0
Views
1,923
Permanent Beginner
P
A
DeviceNet Status Byte
Hello all, Can some one tell me what's in the devicenet status byte? I have 4 1794-ADN nodes and when I map them there is a 16 bit word at the...
Replies
2
Views
2,149
aattanayake
A
S
Problem using status byte
Hi everyone, any help with the following would be greatly appreciated. I am trying to use the status byte S:53L with an EQU instruction. The AB...
Replies
7
Views
2,629
scottsull
S
T
Powerflex 700 Losing Ready Status at the beginning of shift.
I've got a Powerflex 700 that doesn't like to get going in the mornings. This motor will run anywhere from 30 seconds to 5 minutes before it just...
Replies
3
Views
82
ASF
A
J
FactoryTalk Linx server connection has an 'abnormal status'
Not a PLC question but I need expert help on this. My FactoryTalk stopped communicating with the server its hosted on. I had an error stating...
Replies
0
Views
95
jbazely
J
Back
Top Bottom