instruward
Member
I've got a P_AOut function block that isn't doing what I expect it to do.
There is a value PSET_CV of 100% coming from a FIC loop as an input, however the output is still only 0%. I'm expecting it to be near 100% because the flows 0, with a setpoint of 20.
I've looked the the parameters of this block, everything appears fine. There is no faults, its status Sts_Prog is 1 for program mode.
Any tips for what I should be looking for?
There is a value PSET_CV of 100% coming from a FIC loop as an input, however the output is still only 0%. I'm expecting it to be near 100% because the flows 0, with a setpoint of 20.
I've looked the the parameters of this block, everything appears fine. There is no faults, its status Sts_Prog is 1 for program mode.
Any tips for what I should be looking for?