alarm fault dialog limit in Factory Talk View Studio SE 5

NumeG

Member
N
Join Date
Mar 2009
Location
Parma
Posts
6
Hi everyone.
I have a problem with Factory Talk View Studio SE 5.
I have more than 500 alarms.
The HMI send me this message: The number of entries in the Alarm Fault Dialog has exceeded the limit of 500. The oldest entries have been discararded.
Is possible to ingrease this limit (>500 alarms)?
Thanks
 

Similar Topics

L
How to tie alarm messages with fault codes from Servo Drive
I am new to programming rockwell and could use some help. I am using compact logix controller with an Ethernet IP Servo Drive. The servo has 400+...
Replies
13
Views
3,122
janner_10
J
M
Fault and Alarm Management RSLogix5000
Hello All, Just wanted to gather peoples' thoughts regarding fault and alarm management within a program. I've seen programs where AOIs are...
Replies
3
Views
2,006
jholm90
J
D
Alarm/Fault PLC Setup For HMI
Let me start off by saying that I am a CO-OP student and I am very new to PLC's. For my current project I am trying to figure out how to set up...
Replies
10
Views
1,781
dylantzips
D
Saturn_Europa
PLC Fault Alarm Best Practices
My employer has remote sites that that have recently been upgraded from relay control to plc control with a cell modem. The Wonderware DA Server...
Replies
0
Views
2,111
Saturn_Europa
Saturn_Europa
D
Is there a standard for HMI alarm/fault messages?
Is there are standard for what an alarm or fault message must say? More specifically, what details must be supplied in a fault message? For...
2 3
Replies
32
Views
6,877
DennyO
D
Back
Top Bottom