Hi Guys,
Kinda new to the automation field, especially to Rockwell CCW and there is something that is confusing me.
I am using a Micro850 PLC and also a Linmot drive (Link to drive below) for a project. The Linmot has EthernetIP comms to it and it has instructions on how to use it with Studio5k. The problem is with the Micro850, you use CCW and it looks like you can only use EthernetIP to communicate to Rockwell approved devices.
Is there another way that I don't know off that would allow both devices to communicate via EthernetIP (Normally use EtherCAT/OMRON). Secondly, how would a micrologix 850 normally be connected to a SCADA software like Ignition or IDSnet if its stated that they communicate via EthernetIP?
Thanks in advance guys.
Micro850: (2080-LC50-24QBB)
Linmot Drive Link: http://shop.linmot.com/E/ag7000.c12...01-&-pr01/series-c1200/c1250-ip-xc-1s-000.htm
Kinda new to the automation field, especially to Rockwell CCW and there is something that is confusing me.
I am using a Micro850 PLC and also a Linmot drive (Link to drive below) for a project. The Linmot has EthernetIP comms to it and it has instructions on how to use it with Studio5k. The problem is with the Micro850, you use CCW and it looks like you can only use EthernetIP to communicate to Rockwell approved devices.
Is there another way that I don't know off that would allow both devices to communicate via EthernetIP (Normally use EtherCAT/OMRON). Secondly, how would a micrologix 850 normally be connected to a SCADA software like Ignition or IDSnet if its stated that they communicate via EthernetIP?
Thanks in advance guys.
Micro850: (2080-LC50-24QBB)
Linmot Drive Link: http://shop.linmot.com/E/ag7000.c12...01-&-pr01/series-c1200/c1250-ip-xc-1s-000.htm