starter

Hi,

Your question is a little vague, but typically, you can de-rate the contactors and overload by 58% of the full load current.

Regards,

Rob
 
Hi and welcome to the Forum!

Here is a good explaination of reduced voltage star/delta starting for induction motors and the current derating figures for the contactors.

George
 

Similar Topics

W
150 SMC Flex Soft Starter
Hi, I want to start 150 SMC Flex from Studio 5000. I have the AOP and P SMC flex AOI imported in my program. I have also set the logic mask to...
Replies
0
Views
300
waqas
W
S
OT: 110V DC Motor Starter
Hi All, Not strictly PLC, but I'm sure someone works with this stuff and might be able to point me in the right direction. I'm designing a...
Replies
11
Views
1,032
Saffa
S
M
configure cu320 with PC Adapter MPI with STARTER Software
Hi I Have new CU320 Module (6sl3040-0MA00-0AA01) for sinamis G150. i want to download Backup config. of old CU320 to new Module with PC Adapter...
Replies
1
Views
520
JesperMP
JesperMP
gbradley
Soft Starter Recommendation Home AC
We have a 5 Ton Rheem A/C unit at home We only run it in the Summertime, and sometimes in the Fall. It does have a habit of blowing fuses at...
2
Replies
18
Views
2,441
g.mccormick
G
D
OT: Python Quick Starter
I have previously shared this elsewhere, so I apologize if you have already seen it. Here is a basic and quick introduction to Python for PLCs...
Replies
10
Views
2,233
widelto
widelto
Back
Top Bottom